Automotive Sensor Simulator | AutoSim Pro

Description

AutoSim Pro is a specialized signal generator for testing sensors, including leads and connections when installed. In this way, it is possible to tell whether an ECU, a feed, a plug-in connection or a sensor is defective. This allows efficient fault elimination without replacing parts "on suspicion". One of the special features of this device is its easy and intuitive operation via function keys. The display continuously shows the most important settings such as current waveform, frequency, amplitude, offset, ramp time and pulse width.
Multi-Purpose Automotive Simulator
Signal generator
Providing the most important signals: sine, square, triangle and ramps, up to 20 kHz make the device the ideal companion for experiments with all type components and sensors as well as for the analysis of electrical wiring circuits. You have complete control over the output signal: peak-to-peak amplitude, frequency, duty-cycle and pulse width. A microcontroller sets the output voltage in the range of 0V to ±12V accordingly to the programmed curves.
PWM
PWM generator for the dynamic control of vehicle actuators using pulse width modulation. The PWM generator function was specially designed to control flaps, actuators, valves, injectors and smaller DC motors. Generating variable power PWM signal up to 4 A.
Precise DC voltage source
The AutoSim Pro low-noise, high-resolution DC voltage output function is the right choice when a precision source of DC voltage is needed. Its bipolar output delivers up to ±12 V with 10 mV resolution and up to 35 mA of current.
Sensor embedded presets
Automotive Sensor Simulator with built-in preset configurations for simulation of CKP Inductive, CKP Hall Effect, Lambda sensor Zirconia, Lambda sensor Titania and Knock Sensor. You can disconnect sensor from the vehicle harness, inject the signal in the harness and watch the scope to see if the PCM responds positively.
Features:
Handheld standalone device;
Intuitive operation via function keys;
Ultra-fast boot time;
Excellent industrial design;
Operates on both 12 and 24 Volt electrical systems;
Illuminated 2.4" TFT LCD 320х240 display for optimum visibility;
Protection against reverse polarity connection;
Low distortion factor and high signal-to-noise ratio for brilliant signals;
Adjustable frequency range from 0.1 Hz to 20 kHz;
Generating variable power PWM signals up to 4 A;
One-wire hook-up PWM output;
Precise DC voltage source;
Internal Micro SD card for firmware updates.
Applications:
Simulates actual working condition of the most automotive sensors;
Efficient fault elimination without replacing parts "on suspicion";
Simulates O2 sensor signals: Zirconia and Titania;
Checking of basic ECU operation;
Controlling the output signal allows to check the ECU response and operation;
It can drive ECU into “open” or “closed” loop;
Activation of a large number of actuators;
Variable adjustable voltage output from 0 to ±12 volts;
Simulates crank and cam sensors inductive and hall;
In both crank and cam modes you are able to adjust the number of teeth and the missing teeth.
International Buyers – Please Note: Import duties, taxes, and charges are not included in the item price or shipping cost